| | 1-Remove battery, by loosening the two 10mm nuts and taking the battery holddown |
| | | 2-Remove battery terminals with 10mm wrench. |
|
| | 3-As shown battery has been removed. |
| | | 4-Remove plastic battery tray. |
|
| | 5-Let the front VSV hang as it is not used with the CAI. |
| | | 6-Remove front Vacuum Switching valve from top half of Air Box. |
|
| | 7-Unscrew Air Flow Sensor and move to safe place. |
| | | 8-Remove rear VSV, by pushing the blue tab. Let it hang for now. |
|
| | 9-Remove rubber air flow tube from Air Box. |
| | | 10-Unhook rubber air flow tube from throttle body. |
|
| | 11-Unhook 2nd Vacuum Switching Valve tube, will be used later. |
| | | 12-Remove top of Air box. |
|
| | 13-Front Vacuum Switching Valve is no longer needed. |
| | | 14-Remove lower air box housing. |
|
| | 15-Remove plastic air tube near the headlight area. |
| | | 16-As shown plastic hold down for plastic air tube. |
|
| | 17-Pop-up center section of plastic hold down. |
| | | 18-Install fuse box bracket to raise the fuse box so the CAI tube will fit under |
|
| | 19-Install bolt onto the top stud to raise the upper portion of the fuse box. |
| | | 20-From underneath the car, push the CAI filter into the lower portion ofbumpr. |
|
| | 21-Install the CAI tube, be mindful of the wiring in this area. |
| | | 22-Install vibra-mount with the 10mm bolts provided. |
|
| | 23-Install rubber sleeve onto throttle body, then onto the CAI tube. And tighten |
| | | 24-Reinstall rear Vacuum Switching valve tube to the bottom of the CAI tube. |
|
| | 25-Reinstall air flow sensor into CAI tube. |
| | | 26-Tie-strap rear VSV to one of the hoses in the back of the engine area. |
|
| | 27-(XRS only) Install 5mm Vacuum cap onto short tube in the throttle body. |
| | | 28-Slip CAI filter onto the CAI tube. |
|
| | | 30-Reinstall battery tray. |
|
| | | 32-Reinstall battery hold down and reconnect battery. |
|
