| I got this cold cathod tube
from PcMods.com 4" blue kit. |
|
|
| | Remove cube from enclosure & place as shown, remove 4 corner screws(Torx10). |
|
|
| | Turn cube as shown, remove side screws on both sides. |
|
|
| Remove top cover and
disconnect the connector. |
|
|
| | Note the orientation of connector when putting back together. |
|
|
| | Remove side posts by pulling up, do the same for optical drive cover. |
|
|
| Here's what you get when
cover is removed. |
|
|
| | Remove both optical drive screws from both sides. Then carefully remove drive. |
|
|
| | Here's with optical drive removed. Hold drive by the corners ONLY. |
|
|
| | Wiring time, cut both ends off the spade connectors, in order to bypass switch. |
|
|
| | Butt connect together 2 ends.Or you could twist them together and tape them up |
|
|
| | Reroute optical drive power connector under Airport card as shown. |
|
|
| | Position the tube as shown with included velcro, avoid touching the fan bracket. |
|
|
| | I didn't like these bare wires showing so I taped them up to avoid short cir... |
|
|
| | Plug optical drive power connector into tube power supply connector. |
|
|
| Here's the mess of wires,
note wire routing. |
|
|
| | Install optical drive carefully, note the cable routing. |
|
|
| | Position excess cable as shown and resecure the optical drive screws. |
|
|
| | Pull excess out and fold up against the optical drive, see next picture. |
|
|
| | Like so, then carefully reintstall the optical drive cover. |
|
|
| | Avoid pinching the cables when putting cover on,should look like this. |
|
|
| | Position power cables back into cube chassis. |
|
|
| | Here's what the mess looks like from above. |
|
|
| | Position power supply box as shown snug fit against the drive. Velcro not needed |
|
|
| | Put it all back together and hopefully you'll have this. And not smoke! :) |
|
|
| | Only so much text is allowed under the pics, so here's some more info. |
|
|
| | There is a hint of purple. Pictures are very hard to take with digital camera. |
|
|
| | I bypassed the on/off switch but one can be used. It would have to run outside.. |
|
|
| | ..and hang somewhere outside. The light does go out when put to sleep.. |
|
|
| | ..or turned off. Looks MUCH better in person, camera makes it look kinda harsh. |
|
|
| | Leave me a message, tell me what you think. Thanks & have fun with your c... |
|
|  | |
