The engine has switched off
| Troubleshooting table | Symptom/conditions: The engine has switched off | |||
|
||||
| DIAGNOSTICS | ||||
|
Test results
|
||||
| Step | Operations | |||
| 0 |
Check oil level
|
All OK
|
Problems found
|
Intervention
|
|---|---|---|---|---|
|
Check oil level as shown in Procedure 2 |
Go to step 1 | Level other than max | Do Procedure 3 | |
| 1 |
Check oil pressure
|
All OK
|
Problems found
|
Intervention
|
| Check oil pressure as shown in Procedure 4 | Go to step 2 | Press < 40 bar | Do Procedure 5 | |
| 2 |
Check ECU errors
|
All OK
|
Problems found
|
Intervention
|
|
heck there are no errors in the control unit. In particular: |
Go to step 4 | Presence of one or more errors included in the list | Go to step 3 | |
| 3 |
Check problems found
|
All OK
|
Problems found
|
Intervention
|
| Check problems according to Procedure 17 | End of procedure | The problem persists | Go to step 4 | |
| 4 |
Check that the clutch does not drag
|
All OK
|
Problems found
|
Intervention
|
| Check that the clutch does not drag following Procedure 14 | Go to step 6 | The clutch drags | Overhaul the clutch/flywheel kit and replace and broken components. Go to step 5 | |
| 5 |
After intervention on the clutch kit
|
All OK
|
Problems found
|
Intervention
|
| Check that the problem is no longer present. | End of procedure | The problem persists | Go to step 6 | |
| 6 |
The problem persists
|
All OK
|
Problems found
|
Intervention
|
| Check there are no errors or problems on other systems installed don the car | Go to step 7 | Faults are found | Proceed following the indications of Examiner | |
| 7 |
The problem persists
|
All OK
|
Problems found
|
Intervention
|
| Contact technical assistance for additional information on the problem | ||||
* In the presence of this type of error, for safety reasons (at low speed <5 km/h), the Selespeed control unit could ask the injection control unit for an engine stop; it is therefore advised to make an engine control diagnosis.