Picoo Z Tail Motor replacement

If you think you've got poor eyesight now - wait until you've done this little job!
These motors are tiny - and the wires are microscopic! I got mine from servoShop.co.uk. That's the only place I know that sells them at the moment. I decided to attach to the old motor wires rather than the very thin tail boom wires, so I cut the old motor wires off short and stripped the insulation.
A point to note - after fitting this motor I found it ran in reverse so had to unfit it and swap the wires - check it out before you solder it!


Soldering on the wires wasn't too bad - just make sure you use a low powered iron!


OK - so far so good - except for one thing: