| |
| | Icelink v.1.1, Soundgate adapter, and wire harness | |
| | | Disconnecting seat heaters | |
|
| | Our 'workbench' for parts and computer access | |
| | | Cover screwdriver with tape to prevent scratches | |
|
| | Remove mat in armrest and remove black screw. | |
| | | Push power adapter aside to run cables | |
|
| | Attach cables to wire hanger and tape at end. Run from arm rest under E brake. | |
| |
| | Remove rubber coin area, & pry up the plastic piece then unscrew these 2 screws | |
| |
| | You don't need to unscrew the 2 screws in the middle of the picture. | |
| | | Coin storage and front power adapter unscrewed | |
|
| | Remove upper left & upper right screw (not seen) | |
| | | I taped everything to prevent any scratching | |
|
| | Hold the bottom of the unit, use a hook tool (or piece of a metal hanger) | |
| | | This is the area below the radio | |
|
| | Bad pic, the white connector is the AUX in | |
| | | At this point, we plugged everything in, and tested it. Worked great!!!! | |
|
| | We used Velcro on the Soundgate unit to secure it | |
| | | Soundgate unit installed. Perfect spot! | |
|
| | On the opposite side, we Velcro'd the IceLink unit | |
| | | Storage bin back in, rescrewing in the coin storage/power adapter. | |
|
| | | Reconnect seat heaters, and snap trim panel back into place. | |
|
| | We removed the armrest power adapter and cut a notch. | |
| |
| | | Mike operating the hell out of that flashlight....safely. | |
|
| | Marie practicing hammer safety. | |
| | | Cable for dock. We didn't need that first notch. | |
|
| | We opted to screw in the holder for the cradle. | |
| |
| | Armrest with rubber mat back in place. | |
| | | iPod slides in and out very easily. | |
|
| | Finished installation!! 3:18 minutes | |
| |
| | Another view of the installation. | |
| |
| | Installation team. Nice work. | |
| |
| | Rick has a 'similar' installation. | |
| |
