If you don't know what Rife/Crane means then take a look at the links page for pointers to further information on the history and the basics.  "Everyday Practical Electronics" published a good article on the whole subject and this is a good introduction if you're technically inclined.

So, assuming you've got some basics - this site is all about how to build a highly effective (and relatively cheap) Rife/Crane device from a small number of readily available parts (well, at least in the UK they're available, anyway).

Why On Earth Should I Want to Build My Own?

Good question - glad you asked. Well, basically there are three good reasons:

• Lower cost than many "ready built" units
• Much better functionality
• The satisfaction of having built it yourself

Ok, I lied about the last one - but in any case there are still two good reasons for most people to want to build their own.

What Bits Do I Need?

A Rife/Crane unit consists of:

• An accurate pulse generator (hardware)
• Contact pads/leads to apply the pulse to the skin
• A method of running a rife programme (software is preferable)

This web site collects all these together and will show you how you can actually use this technology.