| | Installating the keel hardpoints. |
| | | Connie glassing the access cover. |
| | | The floor hardpoints made the hydrualic installation a snap. |
|
| | I did have to install the seat hardpoints though. |
| | | Cutting the holes for the master cylinders. |
| | | Master cylinders installed. Looks good! |
|
| | Had to make mounting pads under brake pedal mounts becuse of irregular surface. |
| | | Battery shelf with brackets riveted in place. |
| | | Preping the shelf for installation with Aeropoxy |
|
| | Fitting the shelf in place |
| | | Improvised clamps to hold pressure on the shelf while it cures |
| | | Finally past the boat stage. Top and bottom joined, working on door flange |
|
| | Right side door opeining. |
| | | Pilots side door with release coating (duct tape) ready for triax flange |
| | | Firewall outside glased and top cowling cut off. Angle aluminum is for leveling |
|
| | Inside firewall glased in place. glassing overhead is very difficult. |
| | | Modifed access latch design. Will install release cable later. |
| | | Preliminary layup on the door flange. |
|
| | Assemble door latch hardware. |
| | | Backside of door latch mechanism. |
| | | Door mechanism assembled ready to install |
|
| | Preliminary installation of door mechanism |
| | | Final assembly of door mechanism |
| | | Connie glasses in the window of the co-pilots door. |
|
| | Window installed with weight and clamp jig to make it tight |
| | | View from the top of the clamp jig. |
| | | Install the gear control box while the windows set up |
|
